Alumina/epoxy interpenetrating phase composite coatings: I, processing and microstructural development

Interpenetrating phase composite (IPC) coatings consisting of continuously connected Al₂O₃ and epoxy phases were fabricated. The ceramic phase was prepared by depositing an aqueous dispersion of Al₂O₃ (0.3 μm) containing orthophosphoric acid, H₃PO₄, (1-9.6 wt%, solid basis) and heating to create phosphate bonds between particles. The resulting ceramic coating was porous, which allowed the infiltration and curing of a second-phase epoxy resin. The effect of dispersion composition and thermal processing conditions on the phosphate bonding and ceramic microstructure was investigated. Reaction between Al₂O₃ and H₃PO₄ generated an aluminum phosphate layer on particle surfaces and between particles; this bonding phase was initially amorphous, but partially crystallized upon heating to 500°C. Flexural modulus measurements verified the formation of bonds between particles. The coating porosity (and hence epoxy content in the final IPC coating) decreased from ∼50% to 30% with increased H₃PO₄ loading. The addition of aluminum chloride, AlCl₃, enhanced bonding at low temperatures but did not change the porosity. Diffuse reflectance FTIR showed that a combination of UV and thermal curing steps was necessary for complete curing of the infiltrated epoxy phase. Al₂O₃/epoxy IPC coatings prepared by this method can range in thickness from 1 to 100 μm and have potential applications in wear resistance.